Perry scaffold safety manual8/30/2023 ![]() ![]() Section 1926.452(w)(3) and 1926.452(w)(6)(iv) address the manual and powered forces used to move the scaffold. However, there are other requirements that must be met where an employee is on (and moves) a scaffold, and they must be met as well. If a device were installed to permit the casters to be locked while on a scaffold, this particular requirement could be met without dismounting the scaffold. (This section would not apply to workers manually moving a scaffold.) Īs we explained in the Holman letter, 1926.452(w)(2) requires that mobile scaffold casters and wheels be locked to prevent scaffold movement when in use. When using a power system to move the scaffold, the forces must be applied directly to the wheels. Since the force being applied to the scaffold is less than 5 feet from the ground level, this is acceptable as long as it is the lowest point practicable. The worker holds onto something overhead and moves the scaffold with his or her feet. Your letter describes a worker standing on a Baker scaffold that is 2 to 4 feet high. When manually moving the scaffold, the force should be applied as close to the base a practicable, but not more than 5 feet (1.5m) above the supporting surface. These sections address the manual and powered forces used to move the scaffold. Where these conditions are met, the scaffold may be moved while employees are on it. Section 1926.452(w)(6) specifies the requirements for riding a scaffold. If a device were installed to permit the casters to be locked while on the scaffold, this requirement could be met without dismounting. Section 1926.452(w)(2) requires the casters and wheels to be locked when in use. We apologize for the delay in this response.īaker scaffolds, sometimes referred to as Perry scaffolds, are covered by the mobile scaffold section of subpart L. In the Holman letter, we stated: Your questions related specifically to Baker style scaffolds and whether a person could move and work from this type of scaffold without dismounting, with the casters in the unlocked position. In your April 8 letter and telephone conversations with my staff, you have submitted court documents and have described two accidents that you assert are illustrative of your assertion. Specifically, you assert that the guidance we provided in the letter is contrary to the manufacturers' instructions on their use and is not safe. The type of scaffold in question is commonly referred to as a "Perry" or "Baker" scaffold. This issue was addressed in OSHA's letter to Mr. Question: The issue you raise concerns an OSHA interpretation letter regarding whether OSHA construction standards allow employees to stay on a certain type of scaffold with the casters in the unlocked position. We apologize for the delay in responding to your request. This is in response to your December 26, 2001, and April 8, 2002, letters addressed to the Occupational Safety and Health Administration (OSHA) and a subsequent phone conversation with a member of my staff, Mr. ![]() When manually moving the scaffold, the force should be applied as close to the base a practicable, but not more than 5 feet (1.5 m) above the supporting surface. You asked for clarification on Sections and. Section specifies the requirements for riding a scaffold. ![]() We apologize for the delay in this response.īaker scaffolds, sometimes referred to as Perry scaffolds, are covered by the mobile scaffold Section of Subpart L. Your questions related specifically to Baker style scaffolds and whether a person could move and work from this type of scaffold, without dismounting, with the casters in the unlocked position. Roy Gurnham and myself, asking for a clarification of OSHA's mobile scaffold standard §1926.452(w). This is in response to your letters, dated June 12, 1997, addressed to Mr.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |